Lomography Konstruktor Flash Kit: What's Inside and How to Use It

By Camera Wholesalers | Published: 2026-11-02

Category: How-to Guides

A practical walkthrough of the Lomography Konstruktor Flash Accessory Kit: what the bracket, PC cord, and hot-shoe adapter do, plus a step-by-step setup for 35mm flash shooting.

Quick answer

The Lomography Konstruktor Flash Accessory Kit gives you three parts: a flash bracket, a PC-to-hot-shoe adapter, and a PC cord. Mount the bracket to the camera, slide your shoe-mount flash into the adapter, and connect the PC cord to the Fritz the Blitz flash port for off-axis lighting.

Why the bracket changes your lighting

A flash bracket moves the flash away from the lens axis. On a 35mm camera like the Konstruktor, that extra distance reduces the flat, direct look of on-camera flash and gives shadows a slight side direction. The trade-off is bulk: the bracket adds height and a second connection point, so handling feels different from a bare flash. If you mostly shoot in tight spaces or want the smallest possible kit, a bracket may be more hardware than you need.

Matching the kit to your flash and camera

The kit is built around the Konstruktor camera and the Lomography Fritz the Blitz flash, but the PC-to-hot-shoe adapter lets you use any shoe-mount flash with a PC connection. Check two things before buying: whether your flash has a PC port or only a hot shoe, and whether your camera has a PC socket. The catalog does not list trigger voltage or sync speed, so verify those in your flash manual if you plan to mix brands.

Step-by-step Konstruktor flash setup

Attach the bracket to the camera: Screw the bracket's base into the Konstruktor's tripod socket and tighten it until the bracket is firm but not over-torqued. Common mistake: leaving it loose, which lets the flash wobble and can crack the plastic socket over time. Check the bracket by gently rocking the camera; any movement means tighten another quarter turn.
Mount the flash on the adapter: Slide the PC-to-hot-shoe adapter into the bracket's shoe, then slide your flash into the adapter's hot shoe and lock it. Common mistake: forcing a flash with a non-standard foot; if it does not seat easily, stop and check the foot type. The flash should sit level and release only when you press the lock pin.
Connect the PC cord: Plug one end of the PC cord into the adapter's PC socket and the other into the Fritz the Blitz flash port. Common mistake: pushing the connector in at an angle, which bends the center pin and causes intermittent firing. Give each connector a light tug; a seated PC plug will not pull free.
Test fire before loading film: Power on the flash, wait for the ready light, and fire a test shot with the lens cap on. Common mistake: testing with film loaded, which wastes a frame if the sync fails. If the flash does not fire, recheck both PC connections before assuming the cord is faulty.
Set exposure for the flash distance: Use the flash's guide number divided by your subject distance to pick an aperture, then set that aperture on the Konstruktor. Common mistake: ignoring distance and shooting too far away, which underexposes because the flash output is fixed. Recheck the calculation whenever you move closer or farther from your subject.

Product facts

Lomography Konstruktor Flash Accessory Kit: The kit includes a flash bracket, a PC-to-hot-shoe adapter, and a PC cord for connecting to the Fritz the Blitz flash. These three parts cover mounting, flash attachment, and sync connection, so you do not need to source separate adapters for a basic off-camera setup.
Lomography Konstruktor Flash Accessory Kit